3.4 Transportation Operation Lifting procedure When the machine is raised, check that there is no oil leak- age from the hydraulic circuits. When carrying out the lifting operation, please contact your KOMATSU distributor. Lifting work can be carried out only for machines with lifting marks. Before starting the lifting operation, stop the machine in a horizontal place and do as follows. 1. Start the engine, make sure that the machine is horizontal, then set the work equipment to the travel posture. For details, see "Moving the machine (3-75)". 270 mm GK032054 2. Check that the work equipment control lever is at the HOLD position, then set the safety lock lever to the LOCK position.
Free Lock GK032035 3. Stop the engine, check that the area around the operator's compartment is safe, then lock with the safety bar so that the front frame and rear frame do not articulate. GK032216 Lock Free 4. Fit the lifting equipment to the lifting hooks (marked by the lifting mark) at the front of the front frame and the rear of the rear frame. For machines equipped with a rear full fender, remove the rear full fender before carrying out the operation. 5. When the machine leaves the ground, stop for a moment and wait for the machine to stabilize, then continue the lifting operation slowly. GK032228 3-104 WA150-5H – VEAM934100 CAUTION CAUTION