. OPERATION TRANSPORTATION LIFTING MACHINE WARNING 3 - 123 The opera tor carrying out the lif ting operation using a cra ne must be a properl y qualified crane ope Never rais e the machine with an Always m ake sure that the wire rope is of ample strength for the weig ht of this Never lift the machine with the u pper structure swung to t he side. Alwa ys set th e upper structure pa rallel to the undercarriage before lift ing. ng, keep the machine horizontal. under the machine when it is raised.
When lifti ng, keep the machine Never go under the machine wh Never try to lift the machine in an y posture other than the p osture given in the pr ocedure below or usi ng lifting equipment other than in th e procedure below. ne may lose its balance. There is a hazard that the machi NOTICE etails on the machine weight, see the section of "SPECIFICATIONS (PAGE 5-2)". procedure applies to machines with standard specifications. For the d etails on the machine w eight, see the section of "SPECIFICATIONS (P The lifting procedure applies to machines with standard s pecification The meth od of lifting differs acc ording to the attachments and options actually installed.
In such c ases, please contact your Komatsu distributor for informa tion. When liftin g the machine, carry out the operation on fl at ground a s follow 1. Start the engine, then swing the upper structure so that the work equipment is at sprocket (1) end with the track frame and upper structure set parallel. 2. Extend the bucket cylinder and arm cylinder fully, then lowe the work equipment to the ground as shown in the diagram on the right using the boom cylinder. 3. Lower the blade to the ground. 1. Start th e engine, then swin g the upper structure so that the work e quipment is at sprock et (1) end with the trac k frame and upper s tructure set parallel.
and arm cylinder fully, then lowe 2. Extend the bucket cylinder the wor k equipment to the g round as shown in the diagram on the righ t using the boom cy 3. Lower t he blade to the grou 4. Operat e the work equipme nt lock lever to the LO CK position. 5. Stop th e engine, check tha t there is nothing aroun d the operator's co mpartment, then g Close t he cab door and fro nt glass securely.