. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN SWING MACHINERY CASE WARNING 4 - 70 The parts and oil are at high temperature after th e engine is st opped, and may cause serious burns. Wai t for the temperatu re to go d own before starting R efill capacity: 2.0 1. Set a container t o catch the oil immediately under the drain ttom of the machine. g (P) on the machine underside to drain oil, in after the draining. plug (P) at the bo ttom of the machine. 2. Loosen drain plu g (P) on the machine and tighten it aga in after the draining. Tightening torque of drain plug (P) is 4 4 to 93 N·m ( 4.5 to 9.5 Kgf·m, 32.5 to 68 .7 lbft). 3. Loosen bolt (1) a nd slide cover (2). 4.
Add the specified amount of engine oil through dipstick (G) e dipstick (G) with cloth. ck (G) into filler pipe (F), then remove it. insert port. 5. Wipe off oil on th e dipstick (G) with clot 6. Fully insert dipsti ck (G) into filler pipe (F ), then remo 7. The oil should be between the H and L marks on di pstick (G). If the oil is below t he L mark, add engine oil through th e dipstick insertion port. 8. If the oil is above the H mark, drain the excess engin e oil from drain plug (P), an d check the oil level a gain.