. OPERATION DETAILED CONTROLS AND GAUGES SWITCHES (1) (2) (3) (4) (5) (6) Starting switch Fuel control dial Swift deceleration switch Horn switch Lamp switch Alarm buzzer stop switch (7) (8) Pump drive emergency switch Emergency boom swing operation/brake cancel switch Room lamp switch Cigarette lighter (9) (10) Starting Switch Starting switch (1) is used to start or stop the engine. OFF position The key can be inserted or withdrawn. The switches for the electric system except the room lamp and service meter are all turned off and the engine is stopped. ON position Electric current flows in the charging and lamp circuits.
Keep the starting switch key at the ON position while the engine is running. START position This is the engine-start position. Keep the key at this position during cranking. Immediately after starting the engine, release the key. It will automatically return to the ON position. HEAT (pre-heat) position When starting engine in cold weather, set the key to this position. When the key is set to the HEAT position, the pre-heating monitor lights up. Keep the key at this position until the monitor lamp flashes. Immediately after the pre-heating monitor flashes, release the key. The key automatically returns to the OFF position. Then, start the engine by turning the key to the START position.
3 - 15