% O0002 (MX-EXAMPLE #2 - LOWER) (PREPARATION FOR START OF PROGRAM) (INITIALIZE - RAPID, ZX PLANE, TNR COMP CANCEL, CYCLE CANCEL, UPR FEED) N1 G00 G18 G40 G80 G99 N2 G00 G28 U0.0 (ZERO RETURN X-AXIS) N3 G00 G28 W0.0 (ZERO RETURN Z-AXIS) (PREPARATION FOR START OF OPERATION) N4 G54 (WORK COORDINATE SELECTION) N5 T01001 (MCLNR-164D - CNMG432) N6 M138 (SHOWER BED COOLANT ON) N7 M08 (COOLANT ON) N8 M34 (LEFT SPINDLE C-AXIS MODE OFF) N9 M261 (SPINDLE WINDING LOW - REPLACES M41) N10 G50 S2500 (MAXIMUM RPM CAP) N11 G96 S500 M03 P11 (CONSTANT CUTTING SPEED MODE - 500 FPM - LEFT SPINDLE CLOCKWISE) (FACE = ROUGH & FINISH) N12 G00 X3.7 Z0.01 N13 G01 X-0.0625 F0.018 N14 G00 Z0.11 N15 X3.7 N16 Z0.
N17 G01 X-0.0625 F0.01 N18 G00 Z0.1 (OD CANNED ROUGH) N19 G00 X3.5 N20 G00 Z0.0615 N21 G71 U0.125 R0.03 N22 G71 P23 Q32 U0.02 W0.01 F0.018 N23 G00 X0.8903 N24 G01 X1.1817 Z-0.0842 N25 G03 X1.2 Z-0.1063 R0.0313 N26 G01 Z-1.125 N27 G01 X2.7875 N28 G03 X2.8317 Z-1.1342 R0.0313 N29 G01 X2.9817 Z-1.2092 N30 G03 X3.0 Z-1.2313 R0.0313 N31 G01 Z-2.225 N32 G01 X3.5 N33 G00 Z0.1 (TOOL CHANGE PREPARATION) N34 G00 G28 U0.0 (ZERO RETURN X-AXIS) N35 G00 G28 W0.0 (ZERO RETURN Z-AXIS) N36 T01000 (CANCEL OFFSET FOR CURRENT TOOL) N37 M139 (SHOWER BED COOLANT OFF) N38 M09 (COOLANT THROUGH TOOL OFF) N39 M05 P11 (LEFT SPINDLE STOP) N40 M01 (PREPARATION FOR START OF OPERATION) N41 G54 (WORK COORDINATE SELECTION) N42 T02002 (MVJNR-164D - VNMG431) N43 M08 (COOLANT ON) N44 M34 (LEFT SPINDLE C-AXIS MODE OFF) N45 M262 (SPINDLE WINDING HIGH- REPLACES M42) N46 G50 S2500 (MAXIMUM RPM CAP) N47 G96 S600 M03 P11 (CONSTANT CUTTING SPEED MODE - 600 FPM - LEFT SPINDLE CLOCKWISE) - 14 -