OM4054 09/11 Lubrication and Service - Section 40 Page 40-5 10 HOUR (DAILY) INSPECTION Perform a “walk around" inspection prior to each work shift. Check the general condition of the truck. Look for evi- dence of hydraulic leaks. Check all lights and mirrors for dirt and damage. Check the operator's cab for dirty or damaged accessories or controls. Inspect the frame, sheet metal and body for cracks. Notify the proper mainte- nance authority if any discrepancies are found. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS 1.
Check all fluid levels a. Engine Oil- NOTE: Refer to the engine manufacturer service manual for oil recommendations. b. Radiator - Check coolant level and fill with proper mixture as shown in Coolant Specifi- cations at the beginning of this chapter. c. Batteries - Check electrolyte level and add water if necessary. d. Hydraulic Tank - Check oil level in tank, add if necessary. Lube key C. Refer to Hydraulic Tank Service, in this chapter. NOTE: Check the oil level with the truck on a level surface, engine stopped, body down, and oil warm. Oil must be visible in sight glass. Do not overfill. e. Transmission - Check oil level. Add oil if nec- essary. Lube key C.
Refer to Transmission Oil Level Check in this chapter. f. Fuel Tank - Fill as required. g. Differential - On a level surface, the oil level must be even with the plug hole. Refill with oil, as necessary. Lube key B.