OM6011 10/11 VHMS - Section 60 Page 60-9 SETTING THE MACHINE ID AND OPEN ID It is possible to change the machine ID (identifica- tion) and open ID. These pieces of data are cycle data items. When changing the machine serial num- ber for the machine ID or the operator or type of load for the open ID, set the value specified by the cus- tomer beforehand. This will make it possible to check the operator and type of load for the applicable cycle afterwards. 5. Press the ( ) portion of mode select switch 1. 1. Start at the service meter/odometer display, and press the ( ) portion of mode select switch 1 to switch to the operation information display.
The available settings range from 0 to 200; input in order from the first digit. The place for insertion is marked by the cursor. Press the ( or (>) to select 0 to 9. After inputting the value, press the ( ) portion of mode select switch 1. The cursor will move to the next position. Repeat this procedure to input the values for all the digits. Confirm the settings and return to the previous screen. 2. Press the (>) portion of mode select switch 2 until the PLM display is reached. If the ( ) portion of mode select switch 1 is pressed while inputting any value, the value will stay as it is and the cursor will move to the first digit.
If any mistake is made in the input, input again from the first digit. To abandon the input step, press the ( ) portion of mode select switch 1 to return to the previous screen. 6. When setting the open ID, press the (>) portion of mode select switch 2 (at Step 4). 3. Press the ( ) portion of mode select switch 1 to display CALIBRATION. 4. Press the (>) portion of mode select switch 2. ID1 corresponds to the machine ID. The pres- ent setting is displayed on the bottom line. The procedure for setting ID2 is the same as for ID1 (machine ID). Press the ( ) portion of mode select switch 1 several times until the service meter/odometer id displayed.