OM3054 03/13 Operating Instructions - Section 30 Page 30-1 OPERATING INSTRUCTIONS PREPARING FOR OPERATION Walk Around Inspection The safest trucks are those which have been prop- erly prepared for operation. At the beginning of each shift, the operator must perform a careful check of the truck before starting the engine. At the beginning of each shift, perform a careful walk around inspection on the truck before engine start- up. A walk around inspection is a systematic inspec- tion of the truck and its components. The purpose is to ensure that the truck is safe to operate. Safety Is Thinking Ahead Start at the left front corner of the truck.
Move in a counterclockwise direction, from front to rear. Move across the rear. and continue forward up the opposite side of the truck to the original starting point. If these steps are performed in sequence, and are repeated every shift, many potential problems can be avoided. Prevention is the best safety program. Prevent a potential accident by knowing the employer's safety requirements and all necessary job site regulations. Be familiar with use and care of the safety equipment on the truck. Only qualified operators or technicians may operate or maintain the truck. If problems or potential problems are found during the inspection, notify maintenance.
Vehicle break- downs, unscheduled downtime and loss of produc- tion can be reduced. A safe work environment begins before the operator boards the truck. Wear the proper clothing. Loose fitting clothing, unbuttoned sleeves and jackets, jewelry, etc., are a potential hazard. Local work practices may prevent an operator from performing all tasks suggested here. To the extent permitted, the operator must follow this or a similar routine. Use personal safety equipment provided for the operator such as a hard hat, safety shoes, and safety glass. There are some conditions when protective hearing devices must also be worn for operator safety. 1. Start at the left front of the truck.
Visually inspect all lights and safety equipment for exter- nal damage from rocks or misuse. Ensure lenses are clean and are not cracked or broken. When walking to and from the truck, maintain a safe distance from all machines even if the operator is visible. 2. Move behind the front of the left front tire. Inspect the hub and the oil disc brake assem- blies for leaks and abnormalities. Check that all suspension hardware is secure and inspect for evidence of wear. Verify suspen- sion extension is within the proper range. Check for any leaks in the area. 3. Check the engine oil level. Verify engine oil fil- ters or oil lines to filters are not leaking.