OM3216 3/10 Operator Cab and Controls - Section 32 Page 32-29 CHARACTER DISPLAY FIGURE 32-17. Electronic Display Panel 1. Electronic Display Panel 2. Character Display Normally, the service meter/odometer is displayed on the character display. If the machine experiences a failure or if it is neces- sary to perform maintenance, an action code is dis- played to recommend a suitable response. When filter replacement or an oil change is neces- sary, the maintenance monitor caution lamp will flash, and the filter or oil to be replaced is displayed. This will occur after completion of the system check with the key switch in the ON position.
Refer to Filter And Oil Change Display later in this chapter. Check the display to verify that there are no faults before driving the truck. The following table lists the various displays of the character display while in Operator Mode. Service related information can be obtained in the service modes. Refer to the service manual for more infor- mation. * PLM information will override the default display when input is sent from VHMS. An active action code will also override the default display. For details on the payload meter display, refer to Section 60, VHMS - Payload Meter.
Operator mode 1 Service meter, odometer display (default) * 2 Operation Information 3 Reverse travel distance display function 4 Filter replacement, oil change interval display function 5 Telephone number input function 6 Language selection function 7 PLM setup function 8 Action code display function 9 Failure code display function