NOTE: The vehicle should be on level ground when checking the engine oil level. 1. Remove the seats and center console (Prowler) or lift the cargo box (HDX). 2. Unscrew the oil level stick and wipe it with a clean cloth. 3. Install the oil level stick. NOTE: The oil level stick should be threaded in for checking purposes. 4. Remove the oil level stick; the engine oil level should be within the operat- ing range. GZ461A CAUTION Do not overfill the engine with oil. Always make sure the oil level is within the operating range but not above the FULL mark. 5. On the 700 HDX to add oil, remove the seat, oil fill cap, and oil fill plug.
After adding oil, install the fill plug and tighten securely; then install the cover and seat. On the 500 HDX/ Prowler models, add oil to the oil level stick opening until proper oper- ating level is achieved. Oil Level Stick There is an oil level stick for checking the engine oil level. To check the oil level, use the following procedure.
HDX234A 32 Display Fault Description P0266 Cylinder #2 Fuel injector Balance/ Open P0336 Crankshaft Angle Sensor Synchroni- zation P0337 Crankshaft Angle Sensor Circuit/SG P0339 Crankshaft Angle Sensor Intermittent/ Erratic P0340 Camshaft Angle Sensor Synchroniza- tion P0341 Camshaft Angle Sensor Circuit/SG P0342 Camshaft Angle Sensor Intermittent/ Erratic P0480 Fan-Primary/Right Relay Control Cir- cuit P0481 Fan-Secondary/Left Relay Control Circuit High P0482 Fan-Secondary/Left Relay Control Circuit Low/SG/Open P0483 Fan-Secondary/Left Relay Control Circuit P0484 Fan-Primary/Right Relay Control Cir- cuit High P0485 Fan-Primary/Right Relay Control Cir- cuit Low/SG/Open P0500 Vehicle Speed-Sensor P0508 Idle Air Control System Circuit Low/ SG P0509 Idle Air Control System Circuit High/ Open P0520 Engine Oil Sensor/Switch P0562 System Voltage Low P0563 System Voltage High P0601 ECM CAN Communication Shutdown P0615 Starter Relay Circuit P0616 Starter Relay Circuit Low P0617 Starter Relay Circuit High P0630 VIN Not Programmed or Incompatible P0642 Sensor Power Circuit Low P0643 Sensor Power Circuit High P2300 Ignition Coil #1 Primary Circuit Low/ SG/Open P2301 Ignition Coil #1 Primary Circuit High P2303 Ignition Coil #2 Primary Circuit Low/ Open P2304 Ignition Coil #2 Primary Circuit High P2531 Ignition Switch Circuit Low P2532 Ignition Switch Circuit High FUEL OFF Tilt Sensor Activation Code