6. Install the fill plugs and tighten to 16 ft- lb. Hydraulic Brake ! WARNING Be sure to inspect the hydraulic brake system before each use. Always maintain brakes according to the Maintenance Schedule. HDX HDX084A Brake Fluid NOTE: On the Prowler front differ- ential, the lubricant level should be within one inch of the plug. On the rear drive, the lubricant level should be visible at the plug threads. HDX 3. Drain the oil into a drain pan by removing in turn the drain plug from each. HDX081A PROWLER CF107A UTV-367A 1. Check the brake fluid level in the brake fluid reservoir. The fluid level must be maintained between the MAX and MIN level marks.
If the level in the reservoir is low, add DOT 4 brake fluid. NOTE: If fluid must be added, remove the rubber access plug beneath the hood. CF106A 4. After all the oil has been drained, install the drain plugs and tighten to 45 in.-lb. NOTE: The brake fluid reservoir is located on top of the master cylin- der under the hood. CAUTION 2. Press the brake pedal several times to check for firmness. Inspect the oil for any signs of metal filings or water. If found, take the vehicle to an authorized Arctic Cat dealer for servicing. 3. If the pedal is not firm, the system must be bled. 5. Pour recommended oil into each fill hole. 42