OM6009 1/04 Payload Meter III - Section 60 Page 60-15 M: Haul Cycle Too Long Alarm Records The haul_cycle_too_long flag indicates that the haul cycle took longer than 18.2 hours to complete. The times stored for particular events may not be accu- rate. This does not affect the payload calculation. The payload meter stores alarm records to give ser- vice personnel a working history of the system. All codes are viewed using the PC connected to the payload meter. Active codes are also displayed on the two-digit display on the meter itself. Each code has a specific cause and should lead to an investi- gation for correction. Some failures can be over- come by the payload meter.
Haul cycle data will indicate if an alarm condition was present during the cycle. Failures with the suspension or inclinometer sensors cannot be overcome. N: Sensor Input Error An alarm was set for one of the 5 critical sensor inputs during the haul cycle. The five critical sen- sors are the four pressure sensors and the inclinom- eter. Without these inputs, the payload meter cannot calculate payload. A haul cycle with this warning flag should not be considered accurate. Haul cycles with this warning are displayed in red on the Payload Summary window and are not included in the summary statistics for reports or display.
Frame Torque Data Payload meter records the top 5 peak positive and negative frame torque values and the time they occurred. The frame torque is a measure of the twisting action along the centerline of the truck. Pos- itive frame torque is measured when the suspension forces on the front of the truck act to twist the frame in the clockwise direction as viewed from the opera- tor's seat. Negative frame torque is measured when the forces from the suspensions act in the opposite direction. For example, if the left front and right rear pressure rises as the right front and left rear pressure drops, the truck frame experiences a twisting motion along the longitudinal centerline.
In this case, the payload meter will record a positive frame torque. The 5 highest values in the positive and negative direction are stored in permanent memory within the payload meter. Table 2.
Fault Code Data Fault Code Name Description 1 Left front pressure high Input current > 22 ma 2 Left front pressure low Input current 3 Right front pressure high Input current > 22 ma 4 Right front pressure low Input current 5 Left rear pressure high Input current > 22 ma 6 Left rear pressure low Input current 7 Right rear pressure high Input current > 22 ma 8 Right rear pressure low Input current 9 Inclinometer high Input voltage 10 Inclinometer low Input voltage > 5.08 vdc 13 Body-up input failure Payload meter detected dumping activity without receiving a body up signal 16 Memory write failure Indicates possible memory problem at power start up. Cycle power and recheck.
17 Memory read failure Indicates possible memory problem at power start up. Cycle power and recheck. 24 System key-on status Payload Meter failed to correctly start at power up. Cycle power and recheck. 26 User switch fault - SELECT Select switch on for more than 2 minutes, may indicate short to ground 27 User switch fault - SET Set switch on for more than 2 minutes, may indicate short to ground