Cab Radio - Section 70 OM7004 Page 70-6 Bad Tape Detect If the receiver detects a bad cassette, “BAD TAPE” will appear on the display, and the tape will be ejected. If this occurs, the cassette should be removed from the player and should not be re- inserted. CASSETTE PLAYER CLEANING After 35 hours of cassette play, the display will read TP CLEAN for 5 seconds. This indicates that it is time to clean the cassette player. 1. Turn the key switch to ON, and turn the receiver off. If it is desired to use a cleaning tape or a CD adapter in the cassette player, the bad tape detector must be turned OFF. Perform the following steps in order to disable this mode: 2. Disable BAD TAPE DETECT mode.
Press and hold button (3, Figure 70-1) for 5 seconds. “BAD TAPE DETECT OFF” will appear on the display. When this is displayed, the detector has been disabled. 1. Turn the receiver off and turn the key switch to OFF. 3. Turn the receiver on. 2. Press and hold button (3) for 5 seconds. “BAD TAPE DETECT OFF” will appear on the display. When this is displayed, the detector has been disabled. 4. Insert a wet-type, non-abrasive, scrubbing cas- sette cleaner. Follow the instructions provided with the cleaner. 5. Reset the clean tape timer. With the receiver on, press and hold the eject button for 5 sec- onds.
TP CLEAN will appear on the display and the tape icon will flash after 3 seconds has elapsed. After 5 seconds CLN RST will appear on the display. When this occurs, the clean tape timer will be reset to zero hours. If the button was released before CLN RST was displayed, the timer will not be reset. Repeat this procedure to reactivate the bad tape detector. “BAD TAPE DETECT ON” will appear on the display after the detector has been activated.