OPERATION CONNECTING THE BOOSTER CABLES Keep the starting switch at the OFF position. Connect the booster cable as follows, in the order of the numbers marked in the diagram. 1. Make sure that the starting switches of the normal machine and problem machine are both at the OFF position. 2. Connect one clip of booster cable (A) to the positive (+) terminal of the problem machine. 3. Connect the other clip of booster cable (A) to the positive (+) terminal of the normal machine. 4. Connect one clip of booster cable (B) to the negative (-) terminal of the normal machine. 5. Connect the other clip of booster cable (B) to the engine block of the problem machine. STARTING THE ENGINE 1.
Make sure the clips are firmly connected to the battery terminals. 2. Start the engine of the normal machine and run it at high idle speed. 3. Turn the starting switch of the problem machine to the START position and start the engine. If the engine doesn't start at first, try again after two minutes or so. DISCONNECTING THE BOOSTER CABLE After the engine has started, disconnect the booster cables in the reverse order in which they were connected. 1. Remove one clip of booster cable (B) from the engine block of the problem machine. 2. Remove the other clip of booster cable (B) from the negative (-) terminal of the normal machine. 3.
Remove one clip of booster cable (A) from the positive (+) terminal of the normal machine. 4. Remove the other clip of booster cable (A) from the positive (+) terminal of the problem machine. 2-87 WA320-3MC