24. SERVICE PROCEDURE 24.2.11 REPLACE ADDITIONAL BREAKER FILTER ELEMENT (OPTION) WARNING The oil is at high temperature after the engine has been oper- ated, so never replace the filter immediately after finishing operations. Wait for the parts to cool down before changing the filter. Prepare a container to catch the oil. AM091410 1. Place a container under the filter element to catch the oil. 2. Turn filter case 1 to the left to remove it, then take out element 2 . 3. Remove plug 3 from filter case 1 . 4. Clean the removed parts, then install new element 2 and O-ring 4 . 5. When installing, bring the case into contact with the filter holder, then tighten a further 1/2 turns.
AM091420 NOTICE When the breaker is used, replace the element every 250 hours (when the breaker operating ration is more than 50%) as shown in the table on the right. 3-41