11. EXPLANATION OF COMPONENTS METERS 3. ENGINE WATER TEMPERATURE GAUGE This gauge indicates the engine cooling water temperature. If the temperature is normal during operation, the green range will light up. If the red range lights up during operation, the overheat prevention system will be actuated. The overheat prevention system acts as follows. When red range 1 lights up: Engine water temperature monitor 3 flashes. When red range 2 lights up: Engine speed is lowered further to low idling, engine water temperature monitor 3 flashes, and alarm buzzer sounds at the same time. The overheat prevention system is actuated until the tempera- ture enters the green range.
When red range 2 lights, if the engine water temperature is reduced and the fuel control dial is turned to the low idling position, the display will be canceled. 4. FUEL GAUGE This gauge indicates the amount of fuel in the fuel tank. If the fuel level is normal during operation, the green range will light up. If only the red range lights up during operation, there is less than 55 liters (14.5 US gal, 12.2 UK gal) of fuel remaining in the tank, so check and add fuel. After the starting switch is turned ON, the correct level may not be displayed for a moment, but this does not indicate any abnormal- ity.
When stopping the engine, turn the starting switch ON and check that the monitor lamps on items A, B, C and D and the meters light up. 5. DISPLAY When the starting switch is ON, the time and service meter reading is displayed if the condition is normal. If the condition is abnormal, the content of the failure is displayed. When setting the time, the % symbol flashes. AM101350 2-10