2.2.26. Cylinder compression pressure z Stop the engine after warming up, and take out nozzle holder assembly. EFM1004I z Install the special tool (compression gauge adapter) at the nozzle holder hole, and connect the compression pressure gauge there. Standard value 28 kg/cm 2 over Limit value 24 kg/cm 2 Difference between each cylinder Within ± 10 % Condition : Water temperature 20 ° C, EFM1005I Engine rotation 200 rpm 2.2.27. Injection nozzle EFM1006I Normal Abnormal Abnormal z Install a nozzle on the nozzle tester. z If the inspected injection pressure is less than the specified value(285 kg/cm 2 ), adjust using the adjusting shims. z Check the atomizing state and replace it if abnormal.
Technical Information - 37 -