2) Starter motor The sliding-gear starter motor is flanged to the rear of the flywheel housing on the left-hand side. As part of every engine overhaul, the starter pinion and ring gear should be cleaned with a brush dipped in fuel and then a coat of grease should be applied again. Always protect starter motor against moisture. WARNING : Always disconnect the battery earth cable before starting work on theelectrical system. Connect up the earth cable last, as there is of otherwise a rise of short-circuits. 2.2.35. Starting motor z In case of engine maintenance, clean pinion and ring gear thoroughly putting in the fuel, and coat them with grease.
Also, In case of washing car and so forth, inspect the wiring state being careful for not to get. Technical Information - 40 -