Filler Cap/Refuelling Indicator Turn the fi lling cap counter clock- wise. To close it turn the fi ller cap clockwise. The refuelling indicator informs you about the gas level. oil level. Rack Loading Capacity 1. Unscrew the oil level stick and wipe it with a clean cloth. 2. Install the oil level stick without threading it in. 3. Remove the oil level stick; the engine oil level should be above the „L“ mark but not higher than the „F“ mark. q NOTE When loading the vehicle, respect the maximum permissible load of each vehicle! Seat Lock 1. To remove the seat, pull the seat lock lever (located in the middle on the rear of the seat) upwards. Rai- se the rear end of the seat. 2.
To lock the seat into position, slide the front of the seat into the seat retainers and push down fi rmly on rear of the seat. The seat should automatically lock into position. Oil level stick (Automatic trans- mission) There is an oil level stick for che- cking the engine oil level. To check the oil level, use the following pro- cedure: !! WARNING !! Make sure the loads on the front and rear racks will not interfere with the ATV controls or obstruct the view of the operator. Also, make sure the loads are evenly distribut- ed, properly secured and will not shift while operating the ATV.
q NOTE The vehicle should be on level ground when checking the engine Page 29 Vehicle type front rear 400/ 500/650/ 700Diesel 45 kg 90 kg