General maintenance q NOTE Proper maintenance of the ATV is important for optimum performance. Follow all given instructions. General lubrication the fi lter mounting boss (located on the front-right side of the trans- mission case) and allow the fi lter to drain completely. 4. Remove the old oil fi lter and dispose of properly. Do not re-use oil fi lter. 5. Apply oil to the new fi lter O-ring and check to make sure it is positi- oned correctly.; then install the new oil fi lter. Tighten securely. 6. Install the oil fi lter drain plug and tighten securely. 7. Install the oil fi lter drain plug and tighten securely.
Cables None of the cables require lubricati- on; however it is advisable to lubri- cate the ends of the cables periodi- cally with a good cable lubricant. If, at any time, abnormal noises, vibrations, or improper functioning of any component of this ATV is detected, DO NOT OPERATE THE ATV. Take the ATV to an authorized ARCTIC CAT ATV dealer for in- spection and adjustment or repair. q NOTE The following instructions and infor- mation refer to specifi c items in the maintenance and care of the ATV. Engine/Transmission Oil and Filter (400/500/650/700 Diesel) Change the engine oil and oil fi lter at the scheduled intervals.
The en- gine should always be warm when the oil is changed so the oil will drain easily and completely. 1. Park the ATV on level ground. 2. Remove the oil fi ller plug. Be careful not to allow contaminates to enter the opening. 3. Remove the drain plugs from the bottom of the engine and drain the oil into a drain pan. 4. Remove the oil fi lter plug from Page 37