Preparation for storage !! CAUTION !! Prior to storing the ATV, it must be properly serviced to prevent rusting and component deterioration. Then using Arctic Cat Engine Pre- server, rapidly inject the preserver into the air fi lter opening for a peri- od of 10 to 20 seconds. Install the air fi lter. dry area. 10. If possible, store the ATV in- doors. !! CAUTION !! Avoid storing outside in direct sun- light and avoid using a plastic cover as moisture will collect on the ATV causing rusting. Arctic Cat recommends the follo- wing procedure to prepare the ATV for storage.
An authorized Arctic Cat ATV dealer should perform this service; however the owner/ operator may perform this service if desired: !! CAUTION !! If the interior of the air fi lter housing is dirty, clean the area before star- ting the engine. 4. Drain the carburettor fl oat bowl. 5. Plug the hole in the exhaust sys- tem with a clean cloth. 6. Apply light oil to the upper stee- ring post bushing and plungers of the shock absorbers. 7. Take care that all screws, nuts and holding components are tighte- ned properly. 8. Clean the ATV thoroughly. 9. Disconnect the battery cables (negative cable fi rst); then remove the battery, clean the battery posts and cables and store in a clean 1.
Clean the seat cushion with a damp cloth. 2. Clean the ATV thoroughly by washing dirt, oil, grass and other foreign matter from the entire ATV. DO NOT get water into any part of the engine or air intake. Allow the ATV to dry thoroughly. 3. Either drain the gas tank or add a fuel stabilizer to the gas in the gas tank. Remove the air fi lter. Start the engine and allow it to idle. Page 49