3-5 Level setting The level with regard to the manipulation and the performance can be selected and set up in compliance with needs. Power select function Three traveling and material handling modes are available from a selection switch on the multiple display: H (high power) mode, P (power) mode, and S (standard) mode. Travel power control level setting Setting becomes possible only when setting “YES” on the power control selection screen. The power control level can be set besides the S P H mode. 0 Material handling power control level setting Setting becomes possible only when setting “YES” on the power control selection screen. The power control level can be set besides the S P H mode.
1 2 Travel 2nd speed control level setting The travel 2nd speed set up and its cancellation can be done on the screen, and the maximum speed is re- strained from exceeding by the set up speed. 3 Warning 4 Faults or risks can be detected and warning are given . 5 11 Battery over-discharge warning If the battery is further discharged to another preset level after the low battery level warning has been given, all segments in the battery level indicator blink and a buzzer sounds to warn the operator. 6 12 Low battery capacity warning If the battery level goes below a preset level, the battery level indicator blinks.
If the operator turns the key switch from OFF to ON when the battery level is below this level, a buzzer will sound five seconds to warn the operator. 7 8 Overheat warning Overheat warning indicator blinks and a buzzer sounds to warn the operator when traveling motor, or mate- rial handling motor, and the controller overheats. 9 13 10 14 Parking brake ON warning The buzzer sounds when the operator attempt to start the truck with the parking brake set. 11 15 Parking brake OFF warning The buzzer sounds to warn the operator when moving from the drive seat without setting the parking brake.
12 16 Return-to-neutral warning The buzzer sounds when the operator turns the key switch on while depressing the accelerator pedal or turn- ing the direction switch on to start the vehicle. 13 17 Over speed alarm (option) When the set speed is exceeded, it is detected and the speed indicator blinks and the buzzer sounds to give a warning to the operator. Unlike travel 2nd speed control, even if the set speed is exceeded, any speed re- striction is not applied. 18 Diagnostic mode indicator This indicator blinks when the diagnostic mode operates, the error code is displayed, and the buzzer sounds.