. OPERATION EXPLANATION OF COMPONENTS OPERATION EXPLANATION OF COMPONENTS (The lever is installed to position (B) when it is shipped from the factory.) 3 - 27 REMARK The 1st position for the gearshift lever fixes the transmissio n in 1st. There is no autom atic shifting of the transmiss ion. When shifting dow n from 2nd to 1st, press the kick-down s witch on the lift arm control lever. is in auto-shift and the travel speed is below If the transmission 12.5 km/h (7.8 MP H) in any speed range whe n traveling i n either forward or in revers e, the kick-down switch is a ctuated and makes it possible to shift d own to 1st. to carry out load and carry operations.
This makes it easy to carry out load and carry operations. To set to the desire d speed range when traveli ng uphill or d ownhill, or when carrying o ut grading, do as follows. speed range switch on the lift arm control lever. e is fixed at the speed range displayed on the icator on the main monitor. p or down from set speed range he gearshift lever. When fixing the Press the HOLD The speed rang transmission ind switch on the lift arm contr e is fixed at the speed ran icator on the main monitor.
When shifting u p or down from set speed ra Shift gear with t REMARK When the transmis sion has been shifted down from 2nd t o 1st with the kickdown switch, it will shift up from 1st to 2nd when the trave l speed increases. DIRECTIONAL LEV ER This lever (2) is use d to switch the direction of tr avel of the machine between forward a nd reverse. engine, if the directional lever is not at the N e will not start. ARD AL RSE When starting the position, the engin Position (a): FORW Position N: NEUTR Position (b): REVE REMARK The length of the le ver can be adjusted to 3 st ages (positions ( A), (B), (C)).
To adjus t the length, remove the scr ew at the b ottom of the lever knob, slid e the knob to the desired p osition, then tighten the screw again.