ELECTRICAL PANEL 5.7 The loader is equipped with a 12 volt, negative ground electrical system. The fuse and relay panels are located in the engine compartment, attached to the underneath of the engine cover. (fig. C3588) To access the electrical panel: 1 Open the rear door and raise the engine cover. 2 Remove the bolt holding the electrical panel cover closed. (fig. C3588) 3 Open the cover and all fuses and relays will be exposed. (fig. C3589) Visually check the fuses for burnt contacts. The relays are identical and may be checked by swapping one for the other to trace a malfunction. If changing the relays around does not repair the problem, the problem is somewhere else.
The ground bolt should be checked occasionally for cor- rosion and cleaned if necessary. Use a dielectric grease to protect the ground point from the elements. Fuse panel access knob C2051 Electrical Panel 5 1 3 2 13 4 5 12 11 10 6 8 9 7 C3589 ELECTRICAL PANEL LEGEND.(fig. C2052) 1 Engine harness 2 Engine Shut Off (15 Amp, RED) 3 Power Inlet From Ignition Switch Acc (BLK / WH) 4 Grounding Point (LT GRN) 5 Safety Switches (15 Amp, OR / WH) 6 Horn / Option (10 Amp, BRN) 7 Option (10Amp, YL / WH) 8 Manifold Heater Relay (40 Amp) 9 Option (10 Amp YL) 10 Auxiliary Solenoid (10 Amp, RED / YL) 11 Starter Relay (40 Amp) 12 Alternator (10Amp, BLK / WH) 13 Option (10Amp) 5-16