MAINTENANCE PLAN 4.7.8.d CHECKING THE FRONT AXLE OIL LEV- ELS DIFFERENTIAL This check is visual and serves to verify if the lubricant reaches the hole (1); if necessary, top up using the prescribed oil. (See “4.3 FUEL, COOLANT AND LUBRICANTS”). The level hole (1) must be used also as filling hole (use a 17 mm spanner). FINAL REDUCTION GEARS The check must be carried out on each reduction gear posi- tioned with the plug on the horizontal axis. If necessary, move the machine slightly until reaching the specif- ic position that is indispensable for a precise check.
The check is visual and serves to verify if the lubricant reaches the hole (2); if this does not occur, top up using the prescribed oil). (See “4.3 FUEL, COOLANT AND LUBRICANTS”). (Use a 17 mm spanner). 4.7.8.e CHECKING THE REAR AXLE OIL LEV- ELS DIFFERENTIAL This check is visual and serves to verify if the lubricant reaches the hole (1); if necessary, top up using the prescribed oil. (See “4.3 FUEL, COOLANT AND LUBRICANTS”). The level hole (1) must be used also as filling hole (use a 1/2” square spanner). FINAL REDUCTION GEARS The check must be carried out on each reduction gear posi- tioned with the plug on the horizontal axis.
If necessary, move the machine slightly until reaching the specif- ic position that is indispensable for a precise check. The check is visual and serves to verify that the lubricant reach- es the hole (2); if this does not occur, top up using the prescribed oil. (See “4.3 FUEL, COOLANT AND LUBRICANTS”). (Use a 17 mm spanner). 189