MAINTENANCE PLAN 199 DANGER MAX. • Carry out this operation with the machine parked on level ground and raised loader arm with engaged safety lock. • The hydraulic transmission oil must be drained at operat- ing temperature, which is very high, and may cause seri- ous burns; wear insulating gloves, goggles and safety shoes. • Immediately clean any area dirty with oil. • Oils, filters, the coolant and the battery are considered special waste and must be collected and disposed of ac- cording to the anti-pollution regulations in force. MAX. When changing the transmission oil, change also the filter (See “4.7.11.d CHANGING THE HYDRAULIC TRANSMISSION FIL- TER”).
Proceed as follows: 1 - Open the engine hood (See “3.5.1 ENGINE HOOD”). 2 - Remove the drain plug (1) and let the oil flow into a container with suitable capacity. Use a 27 mm spanner. 3 - Carefully remove the filter and change it. (See “4.7.11.d CHANGING THE HYDRAULIC TRANSMISSION FILTER”). 4 - Put back the plug (1) and pour oil until reaching the MIN. lev- el on the dipstick (2). 5 - Start the engine and let it idle to fill the converter and the in- ternal circuits. 6 - While the engine is idling, add oil until reaching the MIN. level again. 7 - When the oil reaches a temperature of approximately 50°C, add oil until reaching the MAX. mark.
For the topping up, see “4.3 FUEL, COOLANT AND LUBRI- CANTS”. 8 - Close the engine hood. MIN. MIN.