Payload Meter III - Section 60 08/06 OM6008 Page 60-18 Fault Code Data Table 2: Fault Code Name Description 1 Left front pressure high Input current > 22 ma 2 Left front pressure low Input current 3 Right front pressure high Input current > 22 ma 4 Right front pressure low Input current 5 Left rear pressure high Input current > 22 ma 6 Left rear pressure low Input current 7 Right rear pressure high Input current > 22 ma 8 Right rear pressure low Input current 9 Inclinometer high Input voltage 10 Inclinometer low Input voltage > 5.08 VDC 11 Speed input failure Not Used. 12 Brake lock input failure Not Used.
13 Body-up input failure Payload meter detected dumping activity without receiving a body-up signal. 16 Memory write failure Indicates possible memory problem at power start up. Cycle power and recheck. 17 Memory read failure Indicates possible memory problem at power start up. Cycle power and recheck. 18 Rear right suspension flat Payload meter detected an undercharged suspension condition on the rear right suspension. 19 Rear left suspension flat Payload meter detected an undercharged suspension condition on the rear left suspension. 20 Time change Payload meter time was changed by more than 10 minutes. The Alarm Set time indicates original time.
The Alarm Clear time indicates the new time. 21 Tare value reset The user manually forced the payload meter to reset the haul cycle empty (tare) sprung weight. This forced the meter into the tare zone state and lost all data for the previous haul _ cycle. 22 Excessive carryback The payload meter detected an empty carryback load in excess of the user-defined carryback threshold on two consecutive haul cycles. 26 User switch fault - SELECT Select switch on for more than two minutes may indicate short to ground. 27 User switch fault - SET Set switch on for more than two minutes may indicate short to ground.