Radio / Cassette Player - Section 70 OM7004 4/05 Page 70-6 Bad Tape Detect If the receiver detects a bad cassette, “BAD TAPE” will appear on the display and the tape will be ejected. If this occurs, remove the cassette from the player and do not re-insert. Cleaning The Cassette Player After 35 hours of cassette play, the display will read TP CLEAN for five seconds. This indicates that it is time to clean the cassette player. 1. Turn key switch to ON and turn off receiver. The bad tape detector must be turned off to use a cleaning tape or a CD adapter in the cassette player. Perform the following steps to disable this mode: 2. Disable BAD TAPE DETECT mode.
Press and hold button (3, Figure 70-1) for five sec- onds. “BAD TAPE DETECT OFF” will appear on the display. When this is displayed, the detector has been disabled. 1. Turn off receiver and turn key switch to OFF. 2. Press and hold button (3) for five seconds. “BAD TAPE DETECT OFF” will appear on the display. When this is displayed, the detector has been disabled. 3. Turn the receiver on. 4. Insert a wet-type, non-abrasive, scrubbing cas- sette cleaner. Follow the instructions provided with the cleaner. Repeat this procedure to reactivate the bad tape detector. “BAD TAPE DETECT ON” will appear on the display after the detector has been activated. 5. Reset the clean tape timer.
With the receiver on, press and hold the eject button for five sec- onds. TP CLEAN will appear on the display and the tape icon will flash after three seconds has elapsed. After five seconds CLN RST will appear on the display. When this occurs, the clean tape timer will be reset to zero hours. If the button was released before CLN RST was displayed, the timer will not be reset.