Service Manual Electrical System 3. Remove the seal and the lens from the Detailed information on standard workshop and safety procedures, and general servicing operations is not included in this manual, which has been prepared to assist qualified service personnel. ODG assumes no responsibility or liability for PERSONAL INJURY or VEHICLE DAMAGE which results from any servicing procedure performed, including those instructions outlined in this manual. headlamp housing. Photo 3 Locate the rubber grommet stored inside the housing of the headlamp. Photo 4 Assembling the EU Vehicle 1. Start at the front of the vehicle. Photo 1 2.
Locate the Headlamp and remove the 3 screws securing the bezel to the body of the headlamp. Photo 2 4. Remove all the mounting hardware from the headlamp except for the last plastic spacer. Photo 5& 6 5. Feed the wiring through the rubber grommet at the back of the headlamp. Photo 7 (Excluding the loomed wir- ing) Ontario Drive & Gear Limited www.odg.com PH.(519)- 662-2840 FAX (519)- 662-2421 ES-19