Electrical System Argo Service Manual Spark Plugs 1. Remove and inspect the spark plugs after every 100 hours of operation. Clean the plugs and reset the gap as detailed in the engine owner’s manual. 2. Replace the spark plugs if the electrodes are corroded or damaged or if the insulator is cracked. Use the correct plug for the engine as detailed in the engine owner’s manual. 3. Re-install the spark plugs carefully, taking care to start the threads properly. Torque the plugs to 10 - 15 ft. lbs (14 to 20 N·m). Do not over tighten. Removing the Headlamp Bulb 1. Open the vehicle hood. 2. Locate the back of the headlamp. 3.
Grasp the headlamp bulb fitting and turn 1/4 turn counter-clockwise to remove from the lens assembly. Photos 1 & 2 Photo 1 Photo 2 4. Spread the two clips that lock the bulb assembly to the wire harness socket and remove the bulb. Photo 3 Installing the Headlamp Bulb CAUTION When installing the new bulb, avoid any contamination of the glass surface. Do not touch the bulb with your fingers. Photo 3 Ontario Drive & Gear Limited www.argoutv.com PH.(519)- 662-2840 FAX (519)- 662-2421 ES-8