ABBREVIATIONS Abbreviations used in this manual are as follows: OPERATIONAL TIPS 1. Safe operation ( 1 ) Make sure that correct size wire is used for hoisting a heavy material (2) After jacking up, always support with rigid racks or stands. 2. Preparation of SSTs and measuring tools ( 1 ) Prepare SSTs and measuring tools before starting operat ion. 3. Clearing and arrangement ( 1 (2) Disassembly of hydraulic equipment shall always be done in a clean place using clean tools. ) Always keep the workshop neat and orderly for easy operation. 4. Genuine Toyota parts Genuine Toyota parts should be used even in the replacement of packings, gaskets and O - rings. 5.
Repairs on electrical system Before doing any repairs on the electrical system, disconnect the cables from the battery terminals. Be sure to disconnect the negative @ cable first. 6. Tightening torque for irlstallation Be sure to observe the tightening torque given in this manual. ' listed in standard bolt If not specified, tighten to the torque & nut tightening torque. 7. Defect status grasp Do not start disassernbly and replacement as soon as a defect is found, but first grasp whether the defect requires disassembly and replacement.
In the case of torque converter for example, do not attempt torque converter disassembly upon a failure in starting the vehicle, but first check such factors as the oil, pressure and rotation status causing the failure.
Abbreviation (Code) Meaning Abbreviation (Code) Meaning ABDC ASSY ATDC ATM BBDC LH L LC MTM OHV 0 PT 0 /S PS After Bottom Dead Center Assem bl y After Top Dead Center Automatic Transmission Before Bottom Dead Center Left Hand Long Life Coolant Manual Transmission Overhead valve Opt ion Oversi~e Horsepower P/S RH SA E SST STD SU B-ASSY T = OOT U/S w/ Power Steering Right Hand Society of Automotive Engineers (USA) Special Service Tool Standard Sub-assem bly Tightening Torque N um ber of Teeth (00) U ndersize With