Group 03 Torque Values Keeping ROPS Installed Properly CAUTION: Make certain all parts are reinstalled correctly if the roll-over protective structure (ROPS) is loosened or removed for any reason. Tighten mounting bolts to proper torque. The protection offered by ROPS will be impaired if ROPS is subjected to structural damage, is involved in an overturn incident, or is in any way altered. A damaged ROPS should be replaced, not reused. TS176 –UN–23AUG88 When installation of equipment on a machine necessitates loosening or removing Roll-Over Protective Structure, mounting bolts must be tightened to 410 ± 82 (300 ± 60 lb-ft).
Specification Mounting Bolts—Torque 410 ± 82 (300 ± 60 lb-ft) ............................ TX,90,RR2484 –19–03AUG92–1/1 TM1859 (14JUL04) 00-03-1 700H Crawler Dozer 071404 PN=25 Hardware Torque Specifications Check cap screws and nuts to be sure they are tight. If hardware is loose, tighten to torque shown on the following charts unless a special torque is specified. TX,9000,BD2408 –19–02DEC96–1/1 00 03 1