4 Top speed is normally limited when operating in differential gear lock. If conditions require more en- gine power when riding forward, push and hold this switch to override the differential gear lock speed limiting function. (See page 4-10.) Releasing the switch restores the speed limiting function. While the override switch is pushed, the segments of the speedometer digits will appear as shown in the figure. EBU18190 Override switch “OVERRIDE” 1. Override switch “OVERRIDE” 4-8 EBU18100 Start switch “ Push this switch to crank the engine with the start- er.
See the starting instructions on page 6-1 prior EBU18151 Light switch “ / /OFF” Set this switch to “ ” to turn on the low beams and the taillight. Set the switch to “ ” to turn on the high beams and the taillight. Set the switch to “OFF” to turn off all the lights. Do not use the headlights with the engine turned off for an extended period of time, oth- erwise the battery may discharge to the point that the starter motor will not operate properly. If this should happen, remove the battery and EBU18170 Horn switch “ Press the switch to sound the horn. to starting the engine. CAUTION: CAUTION: recharge it. ECB00050 ECB00040