Acorn Computers BBC Micro Model B w/8271 — Acorn BBC Micro Model B w/8271 User Guide Manual PDF (EN)

436 Accumulator addressing Th final addressing mode used by the assembler is known as accumulator addressing. This is where the accumulator is addressed rather than a memory location, and is specified by placing A in the operand field. For example: ASL A means ‘shift the contents of the accumuator one bit to the left’. Note that this means that ‘A’ cannot be used as a variable name within an assembly language program. Finally, it must be re-emphasised that each assembly language mnemonic can only use some of the addressing modes detailed above; see the table in the appendix for the addressing modes used by each instruction.

Placing machine code programs in memory When the assembler is creating a machine code program the code produced is placed in memory starting from the address in P% (unless O% is used, see OPT below). The assembler updates the value in P% as it is assembling, and at the end of an assembly operation the value in P% represents the address of the first ‘free’ memory location after the machine code program. In the example program shown above, the value of P% is allocated directly (at line 20). This method of setting up P% is somewhat dangerous, since you have to be sure that location &3500 and (in this case) the nine locations beyond &3500 do not contain anything important.

A much safer way of setting up P% is to dimension a block of memory using a variation of the BASIC DIM keyword. The example program below illustrates this feature, and other features used with assembly language: 5 REM Uses assembly code to change to mode 4 and draw a triangle 10 OSWRCH=&FFE3 20 DIM GAP% 100 30 DIM data &1C 40 FOR opt%=0 TO 3 STEP 3 50 P%=GAP% 60 [ 70 OPT opt% 80 .entry LDX#0 \ set data block offset to zero 90 .loop LDA data,X \ load VDU parameter from data block 100 JSR OSWRCH \ perform VDU command 110 INX \ increment offset 120 CPX #&1C \ has all data been loaded?