Basic operation en Basic operation 7 Basic operation 7.4 Setting the temperature Basic operation Setting the refrigerator compartment temperature 7.1 Switching on the appli- ance ▶ Press the required temperature. 1. Electrically connect the appliance. The recommended temperature in the refrigerator compartment is 4 °C. → Page 10 Note: If the appliance has been previously switched off using the control panel, press and hold Setting the freezer compartment temperature for three seconds. a The appliance begins to cool. a A warning signal sounds and the ▶ Press the required temperature. The recommended temperature in the freezer compartment is −18 °C.
temperature display (freezer com- partment) and flash be- cause the freezer compartment is still too warm. 2. Switch off the warning signal using Additional functions 8 Additional functions . a goes out as soon as the set temperature has been reached. 3. Set the required temperature. Additional functions 8.1 Super cooling With Super cooling, the refrigerator compartment cools as cold as pos- sible. Switch on Super cooling before pla- cing large quantities of food. Note: When Super cooling is switched on, increased noise may occur. → Page 15 7.2 Operating tips Ў Once you have switched on the appliance, the set temperature is only reached after several hours.
Do not put any food in the appli- ance until the set temperature has been reached. Ў The front panels of the housing are ▶ Press . a lights up. Switching on Super cooling temporarily heated slightly. This prevents condensation in the area of the door seal. Ў When you close the door, a va- Note: After approx. 6 hours, the ap- pliance switches to normal operation. cuum may be created. The door is then difficult to open again. Wait a moment until the vacuum is offset. Switching off Super cooling ▶ Press . 7.3 Switching off the appli- ance ▶ Press and hold for three seconds. 15