en Basic operation 2. To loosen the ice cubes, twist the ice cube tray slightly or hold it briefly under flowing water. 7.4 Setting the temperature Setting the refrigerator compartment temperature Basic operation 7 Basic operation ▶ Press / (Refrigerator compart- ment) repeatedly until the temper- ature display (refrigerator compart- ment) shows the required temper- ature. The recommended temperature in the refrigerator compartment is 4 °C. → ""OK" sticker", Page 19 Basic operation 7.1 Switching on the appli- ance 1. Press . a The appliance begins to cool.
a A warning signal sounds, the tem- perature display (freezer compart- ment) flashes and lights up because the freezer compartment is still too warm. 2. Switch off the warning signal using Setting the freezer compartment temperature ▶ Press / (Freezer compartment) repeatedly until the temperature display (freezer compartment) shows the required temperature. The recommended temperature in the freezer compartment is −18 °C. . a goes out as soon as the set temperature has been reached. 3. Set the required temperature. → Page 16 7.2 Operating tips Additional functions 8 Additional functions Ў Once you have switched on the appliance, the set temperature is only reached after several hours.
Do not put any food in the appli- ance until the set temperature has been reached. Ў The housing around the freezer Additional functions 8.1 Super cooling With Super cooling, the refrigerator compartment cools as cold as pos- sible. Switch on Super cooling before pla- cing large quantities of food. Note: When Super cooling is switched on, increased noise may occur. compartment is temporarily heated slightly. This prevents condensa- tion in the area of the door seal. Ў When you close the door, a va- cuum may be created. The door is then difficult to open again. Wait a moment until the vacuum is offset. ▶ Press (Refrigerator compart- ment). a (Refrigerator compartment) lights up.
Switching on Super cooling 7.3 Switching off the appli- ance ▶ Press . Note: After approx. 15 hours, the ap- pliance switches to normal operation. 16