• Install the front wheel with spacer (1) and speed- ometer drive (2). e Attention: Locate stop on slider tube (A) in recess in speedom- eter drive (B). R22000010 • Tighten the retaining screw (3). • Install the front brake calipers. • Release the motorcycle from the assembly crane, BMW No. 46 5 640 . • Compress the front fork firmly several times. • Tighten the clamp screws. d Warning: The brakes are not ready for use until the brake pads have been bedded against the brake discs with the ignition switched on. • Using the straps, secure the front of the motor- cycle to the assembly crane, BMW No. 46 5 640 . e Attention: Do not damage the brake lines, Bowden cables and fairing panels.
• Raise the front of the motorcycle. e Attention: Make sure that the motorcycle cannot topple side- ways. X Tightening torque: Bolt of quick-release axle ............................ 30 Nm Clamping screws of quick-release axle ....... 22 Nm Brake caliper to fork slider ........................... 30 Nm • Remove rear straps. • Using the assembly crane, BMW No. 46 5 640 , carefully push the motorcycle forward off the pal- let. • Extend the main stand and lower the motorcycle Installing front mudguard Note: Do not apply handbrake lever or footbrake lever with brake calipers removed/front wheel removed. 00.17 Assembling the motorcycle Installing the front wheel e Attention:
Degrease all brake discs. 1 3 2 A B R22000020 R22000020 • Remove screws securing the front brake cali- pers. R22000030 R22000030