13 72 000 Replacing intake air filter element (Inspection III) in very dirty and dusty operating conditions, replace every 10,000 km (6,000 miles) or even more frequently if necessary R22000130 • Open clips securing air filter cover. • Replace air filter element. • Close air filter cover. 12 31 240 Replacing Poly-V belt (Inspection III) every 60,000 km (36,000 miles) • Remove left side fairing panel. • Remove front intake pipe. • Disengage fairing bracket from end cover on left. • Remove front cover. 00.35 3 2 4 1 RS110480 • Slacken alternator securing screws (1,3,4). • Remove old Poly-V belt. L Note: Loop Poly-V belt over crankshaft belt pulley first, then over alternator belt pulley.
• Install new Poly-V belt. Poly-V belt adjusting procedure: • Place the Poly-V belt in position, tension it and turn the engine over once, then relieve belt ten- sion. Poly-V belt tensioning procedure: 1 Slightly tighten hex nut (1) on adjusting screw (2) by hand (do not use tools). 2 Tighten adjusting screw (2) with a torque wrench and keep preload applied. 3 Tighten upper retaining nut (3), then remove torque wrench from adjusting screw. 4 Tighten all screws and nuts. X Tightening torque: Preload for Poly-V belt ................................... 8 Nm Belt pulley to alternator ................................ 50 Nm Belt pulley to crankshaft...............................
50 Nm Alternator to alternator support cover........... 20 Nm R22110010