Checking brake pads and discs for wear/replacing Brake pads, rear brake (Inspections II and III) Checking brake pads for wear Brake pads, front brake 1 R22000170 2 • Visually inspect the brake pads. – Make sure that the brake disc is not visible through the bore (arrow) in the inner brake pad. • If necessary, check/measure thickness of brake pads. e Attention: Do not permit brake pad thickness to fall below the min- imum value. Always replace the brake pads as a com- plete set. R22000160 • Visually inspect the brake pads. – Wear indicators (1) must be clearly visible. • If necessary, check/measure thickness of brake pads. e Attention:
Do not permit brake pad thickness to fall below the min- imum value. Always replace the brake pads as a complete set. Minimum pad thickness: ........ 1.0 mm (0.0393 in) – If the brake disc is visible through the bore in the wheel-side brake pad, the brake lining is worn to its minimum permissible thickness. Minimum pad thickness: ......... 1.0 mm (0.0393 in) • Check that colour codes of brake pads and brake calipers (2) match. Colour code: ................................................. white 00.37