• Installation is the reverse of the removal proce- dure. • Check operation of the brake system with the ig- nition switched on. 34 21 200 Brake pads, rear brake e Attention: Integral brakes, the front brake must be ready for use. X Tightening torque: Brake caliper to rear wheel drive .................. 40 Nm R22000180 • Remove keeper (arrow) from retaining pin. • Drive the retaining pin out towards the wheel side. • Remove brake caliper. • Remove brake pads. e Attention: Integral ABS Press back pistons in brake caliper brake pad only far enough to allow the brake disc to the slipped in. Make sure that the fluid level in the wheel-circuit res- ervoir does not rise above “max”.
Risk of fluid escaping. If fluid escapes, proceed in accordance with “in- structions for filling reservoir”. • Force back the pistons. R22000280 • Check that spring is correctly positioned and se- cure. – Engraved arrow (arrow) points in direction of travel. 00.39