Instructions for filling rear wheel circuit reservoir e Attention: Integral brakes, the front brake must be ready for use. MAX MIN 34 1 536 R28340090 • Top up the fluid in the wheel-circuit reservoir until one of the three protrusions in the filler neck just touches the surface of the fluid (arrow). • Remove resetting tool, BMW No. 34 1 531 , and adapter, BMW No. 34 1 536 . 34 1 531 R28000170 d Warning: Make sure that the wheel-circuit reservoir does not overflow when the brake pads/brake calipers are in- stalled. • Top up fluid in rear wheel-circuit reservoir to “MAX” mark if necessary. • Fully tighten resetting tool, BMW No. 34 1 531 , and adapter, BMW No. 34 1 536 .
• Install rear brake pads and brake caliper. • Disconnect the container from the wheel-circuit reservoir. • Hand-tighten cap of rear wheel-circuit reservoir. • Check operation of the brake system with the ig- nition switched on. e Attention: After all the work on the brake system has been completed, run a bleed test using the BMW MoDiTeC. e Attention: The piston in the base of the wheel-circuit reservoir must always be covered by the fluid, as otherwise air can be drawn into the brake system. Bleed the system again if this happens. • Switch on the ignition. L Note: After switching on the ignition, always wait for the BMW Integral ABS to complete its self-diagnosis.
Do not operate the brake lever until self-diagnosis has completed. • Perform bleed test with BMW MoDiTeC. ( a 00.29) • Install fuel tank. Brake fluid ...................................................DOT 4 X Tightening torque: Bleed screw in rear brake caliper ................... 5 Nm Brake caliper to rear wheel drive .................. 40 Nm • Operate the footbrake lever until the pistons of the rear brake caliper are in contact with resetting tool, BMW No. 34 1 531 , and adapter, BMW No. 34 1 536 . 00.46