1 2 R22340070 34 52 111 Removing and installing rear Integral ABS sensor • Remove front and rear seats. • Remove right case, if necessary. • Remove small right side fairing panel. • Remove the cable ties securing the sensor ca- ble. • Disconnect plug (1) of sensor cable. • Before removing/installing, clean the sensor bore. • Remove sensor (2). • Installation is the reverse of the removal proce- dure. • Coat O-rings with oil before installing. e Attention: Route the sensor cable correctly. X Tightening torque: Sensor ........................................ hand-tight, 4 Nm 34.10