• Close the bleed screw. • Release the brake and switch off the ignition. • Disconnect the brake bleeding device from the bleed screw. • Disconnect the container from the wheel-circuit reservoir. MAX e Attention: After changing and/or bleeding the brakes, always top up the fluid in the wheel-circuit reservoir to the correct level in accordance with the instructions. MIN R28340090 e Attention: The brake fluid must always be visible in the contain- er, because the piston in the base of the wheel-cir- cuit reservoir must always be covered by the fluid. The procedure must be repeated if the fluid drops below the “min” level. • Very gently press the footbrake lever until the pump just starts up.
• Open the bleed screw, while topping up the con- tainer with new brake fluid if necessary. • Pump out the brake fluid with virtually no pres- sure to begin with, then vary the brake pressure. L Note: The higher the brake pressure the faster the fluid is pumped through the system, which means that the level in the wheel-circuit reservoir drops all the more rapidly. • When the brake fluid is clear and free of bubbles, continue pumping until the fluid in the container just disappears from view. 34.27