• Install rear brake pads and brake caliper. • Disconnect the container from the wheel-circuit reservoir. • Hand-tighten cap of rear wheel-circuit reservoir. • Check operation of the brake system with the ig- nition switched on. 34 00 Integral ABS Reading fault memory with BMW MoDiTeC • Remove front and rear seats. • Connect the BMW MoDiTeC to the diagnosis 34.29 e connector. Attention: • Read out the fault memory. After all the work on the brake system has been • Clear the fault memory if applicable, or perform completed, run a bleed test using the all requisite repair work. BMW MoDiTeC. • Perform bleed test with BMW MoDiTeC. 34 00 Integral ABS • Install fuel tank.
Performing bleed test with BMW MoDiTeC Brake fluid....................................................DOT 4 X • Remove front and rear seats. Tightening torque: • Connect the BMW MoDiTeC to the diagnosis Bleed screw in rear brake caliper ................... 5 Nm connector. Brake caliper to rear wheel drive .................. 40 Nm d Warning: When performing maintenance and repair work on BMW Integral ABS, never pump quickly or vigorously. • Perform bleed test. • Perform all requisite repair work.