HOW TO USE TOPDON BT200 will test each battery according to the selected actual system standard and rating marked on the battery, to get the accurate results. 1. Battery Test (12V Only) The engine and all other accessory loads must be OFF in order to have accurate results. Turn on the vehicle headlamps for 2~3 minutes until the battery voltage drops back to normal value if the battery is just fully charged. 1.1 Before Test 1) The RED (+) Positive Battery Clamp is connected to the (+) positive battery terminal, and the BLACK (-) Negative Battery Clamp is connected to the (-) negative battery terminal.
Ensure that the clamps have a firm, secure grip on the battery terminals for accurate results. 1.2 Steps 2) The device will jump to main menu automatically after 3 seconds, select "BATTERY TEST" and then press "ENTER" to continue. MAIN MENU BATTERY TEST CRANKING TEST CHARGING TEST REVIEW DATA LANGUAGE ABOUT 3) Press "▲" or "▼" to select the "BATTERY TYPE" (specified on the battery rating label), then press "ENTER" to continue. EN I 8