Chapter 4: BIOS IDE Channel 0 Master/Slave/SATA Port2/SATA Port3/Ext. Primary Master/Slave These settings allow the user to set the parameters of slots indicated above. Hit to activate the following sub-menu screen for detailed options of these items. Set the correct configurations accordingly. The items included in the sub- menu are the following: Type Use this feature to select the type of storage or ROM drive. Select Auto to allow the BIOS to automatically determine the drive's type/capacity (number of heads, etc.). Select User to manually enter the parameters for the storage device in- stalled on this particular port.
For hard drives, enter a number between 1 to 39 to select a pre-determined HDD type from the Drive Table. Select CDROM if a CDROM drive is installed. Select ATAPI if a removable disk drive is installed. Note: Select User for any device or legacy device that is not supported or auto- matically detected under Auto. This enables you to manually enter parameters for devices that are not otherwise available in the BIOS' drive table. CHS Format The following items will be displayed by the BIOS: TYPE: This item displays the type of IDE or SATA Device. 4-5