Motor 1 Remove the following assemblies: Toner cartridge, media tray, and cable pod. See “Toner cartridge” on page 15 through “Cable pod” on page 17. Left side and back covers. See “Left side cover” on page 18 through “Back cover” on page 19. Hint Removing the fuser is not necessary, but doing so will make replacing the motor easier. See “Fuser assembly” on page 42. 2 Disconnect the motor cable connector (callout 1) on the side of the motor. 3 Remove the two screws (callout 2) from the motor and lift the motor out of the printer. 2 2 2 1 Figure 12.
Remove the motor (fuser removed for clarity) Note When replacing the motor, verify that the connector (callout 1) is located toward the front of the printer. Q1342-90910 External assemblies 23