Face-up roller 1 Remove the following assemblies: Toner cartridge, media tray, and cable pod. See “Toner cartridge” on page 15 through “Cable pod” on page 17. Left side, back, right side, and top covers. See “Left side cover” on page 18 through “Top cover” on page 29. Fuser assembly. See “Fuser assembly” on page 42. 2 Turn the fuser assembly over and remove the gear (callout 1) from the face-up roller 3 Release the tab (callout 2) on the face-up roller bushing and rotate the bushing forward until the pin releases. Remove the bushing. 4 Slide the face-up roller toward the gear end until the roller clears the roller retainer (opposite the gear end), and lift it out of the fuser assembly.
2 1 2 Figure 36. Remove the face-up rollers Note When replacing the face-up roller bushing, verify that the locking pin is seated correctly to prevent the roller from slipping out of the roller retainer. Q1342-90910 Internal assemblies 47