Initial hardware setup 1 Press the shipping lock (callout 1), located on the left side of the scan engine, toward the front of the MFP to unlock it. Note Show the user where the shipping lock is located. Before the MFP can be moved, the flatbed optical unit must be “parked” and locked. To lock the carriage, touch MENUS , then CONFIGURE DEVICE , touch RESETS , touch LOCK CARRIAGE , and then engage the mechanical lock. 2 2 1 Figure 12. Initial hardware setup (1 of 4) 2 Open the left door. 3 Pull the shipping tape straight back to remove the two fuser shipping locks. Make sure the fuser levers are in the “down” position before printing.
4 Remove the remainder of the orange shipping tape inside the left door. 5 Open trays 2, 3, and 4, and remove the shipping tape and the tray locks (two per tray). 6 Make sure that the custom/standard switch is in the “standard” position. Show the user where to locate this switch and explain its purpose. 7 Open the top of the ADF and pull out the packing material (callout 2). Figure 13. Initial hardware setup (2 of 4) C8523-90921 Setup 33 2 2 2