12-12 BIW assembly 12. Body Sheet Metal and Paint Repair Manual 3. Removal Cutting position Note: - Cutting must be performed in a straight line and avoid reinforcements. - Cutting can affect the strength of the body. Therefore, treatments in terms of reliability and safety must be done according to the relevant regulations of this manual. Note: - Do rough cutting on new parts in joining area. 20 mm-30 mm length must be reserved at position -a- part for overlapping. CAUTION: - When cutting panels, be careful not to damage surrounding panels or any panels below them. If any panel is damaged, it must be repaired. It is prohibited to drill or cut in areas where harnesses are installed. Note:
- Check that hoses or wires at drilled or cut positions are not damaged. VOYAH FREE A Allowable cutting position B Bending position C Reinforcement Repair tool A Pneumatic saw -a- position size 20 - 30mm